ABB Authorized Switchgear
ABB MDmax ST and MDrail-E systems built under ABB authorisation and type-tested in Zhenxiang’s own configuration, with CE, IECEE CB and UL certificates on specific ranges.
Product family
2 product families
Representative ABB illustrationABB MDmax ST low-voltage switchgear
Representative ABB illustrationABB MDrail-E power distribution and control cabinets
Selection guide
Which ABB system is used where?
Selection depends on where the supply comes from, the current to be carried, the site conditions and whether the installation can be interrupted for maintenance. Final values follow the single-line diagram, selectivity study and short-circuit calculation.
| Family | Location and role | Typical rating | Certification |
|---|---|---|---|
| MDmax ST | Main LV switchboards, generator and motor-control boards | 400–6300 A main busbar | ABB Licensed Panel Builder; CE, IECEE CB; UL 891 (MDmax-ST 4500) |
| MDrail-E | Sub-distribution, transfer-switch, control and drive cabinets | 10–630 A | ABB partner; UL 891, UL 1008, UL 508A |
Design principles
Standards and design principles
ABB design rules
Systems are built to ABB system design and assembly instructions.
Own type tests
Zhenxiang holds its own type-test reports on MDmax ST (400–6300 A) and MDrail-E (10–630 A).
CE and IECEE CB
TÜV Rheinland CE and IECEE CB certificates on MDmax ST, main busbar 4000–6300 A.
UL certification
UL Certificates of Compliance for MDmax-ST 4500 (UL 891), MDrail E (UL 891), MDrail-E-700 (UL 1008) and industrial control panels (UL 508A).
Production process
From enquiry to commissioning
Design, production and testing sit under one roof, so responsibility stays at one point from the first drawing to site support.
- Enquiry and analysisSend a single-line diagram, load list or panel schedule. An engineer confirms voltage, short-circuit level, forms of separation and applicable standards within 24 hours.
- Proposal and drawingsBudgetary quotation in five working days, then general-arrangement drawings, busbar sizing and a bill of materials for approval.
- Order and engineeringApproved drawings release procurement of Schneider, ABB or specified components and sheet-metal programming.
- Fabrication and assemblyLaser cutting, CNC bending, powder coating, busbar processing, primary assembly and secondary wiring in Shaoshan.
- Factory acceptance testDielectric, loop-resistance, insulation, earth-continuity, IP and current-injection tests; customers and consultants welcome to witness.
- Delivery and after-salesExport packing, sea or air freight, commissioning support and a 7×24 service line with trained service engineers.
Let's confirm the right board for your project
Send a single-line diagram, load list or a plain list of requirements. Our engineers set the board type, form of separation and ratings with you.